Computers and Related Hardware/Software

Started by groink · 6 Oct 2003 · 5,867 replies

General Discussion Page 209 of 294

27 Jan 2008, 04:38 #4161
bmwracer wrote:
It wouldn't really save that much because the drive is always spinning when your PC is on... The motor bearing of the HD is probably is biggest wear and tear item in a drive.

Not sure if external drives have some kinda power down mode when not in use for long periods... They also have slower data transfer rates than internal drives...

That's good to know. Thanks. I guess extra space for downloading is my only criteria now. So it's a toss-up between an internal or one of those Western Digital "My Book" externals.
27 Jan 2008, 13:50 #4162
I think i've screwed up my comp.

I bought a 1G ram stick today, opened up my comp, removed the 512MB stick, put in the new one, closed it up and turned it on. It went on for a second or 2, then shut off, and now it won't boot :( No power light, nothing.

So I think the motherboard or PS is fried :( I tried putting the old ram stick back, but it made no difference :(
27 Jan 2008, 13:55 #4163
Anime Dad wrote:I think i've screwed up my comp.

I bought a 1G ram stick today, opened up my comp, removed the 512MB stick, put in the new one, closed it up and turned it on. It went on for a second or 2, then shut off, and now it won't boot :( No power light, nothing.

So I think the motherboard or PS is fried :( I tried putting the old ram stick back, but it made no difference :(

You did buy the correct RAM module for your PC, ne?

No beep tones at all?

Try resetting the CMOS by moving that jumper on the motherboard...
27 Jan 2008, 13:59 #4164
bmwracer wrote:
You did buy the correct RAM module for your PC, ne?

No beep tones at all?

Try resetting the CMOS by moving that jumper on the motherboard...


No, that was the problem. I realised later that the original ram was DDR400, the new one was DDR667 :banghead: I'm so stupid :banghead:
27 Jan 2008, 14:04 #4165
Anime Dad wrote:No, that was the problem. I realised later that the original ram was DDR400, the new one was DDR667 :banghead: I'm so stupid :banghead:

That shouldn't toast the PC... :sweat:

It's just a faster DDR, ne?

Give your system time to settle and try booting with the old module.
27 Jan 2008, 14:07 #4166
Anime Dad wrote:

No, that was the problem. I realised later that the original ram was DDR400, the new one was DDR667 :banghead: I'm so stupid :banghead:

So, are you saying you bought incompatible RAM?
27 Jan 2008, 14:11 #4167
I thought so too, but when I pulled the 667 out and compared it to the 400, the notch is in a very slightly different spot.. I don't know how I managed to get it in.
27 Jan 2008, 14:20 #4168
Anime Dad wrote:I thought so too, but when I pulled the 667 out and compared it to the 400, the notch is in a very slightly different spot.. I don't know how I managed to get it in.

Wait, are you talking DDR or DDR2?

Or did you plug a DDR2 into a DDR socket?
27 Jan 2008, 15:32 #4169
Anime Dad wrote:I think i've screwed up my comp.

I bought a 1G ram stick today, opened up my comp, removed the 512MB stick, put in the new one, closed it up and turned it on. It went on for a second or 2, then shut off, and now it won't boot :( No power light, nothing.

So I think the motherboard or PS is fried :( I tried putting the old ram stick back, but it made no difference :(


I had that problem once after putting in a ram stick incorrectly... not completely seated before I turned it on. It fizzled for a moment then nothing.... waited 15 minutes ... tried to turn it on... nothing. Finally I read the manual... It actually had that problem in there. The resolution, unplug from wall.... wait for a while. Plug back into wall and computer had a new life. I suppose there is some capacitor that can't release it's energy until all power sources are removed. :bonk:
27 Jan 2008, 23:09 #4170
16G SDHC memory card

As the resolution of digital cameras increases, memory cards with larger capacity are needed. Evergreen has released a 16G SDHC memory card with high-speed writing and reading access (class 6). You don't have to worry about memory capacity anymore and can take photos and videos with your high-spec camera as much as you want.

DNF-SDH16C6, Evergreen
9,999 yen
http://www.donya.jp/item/5233.html

January 23, 2008
28 Jan 2008, 00:54 #4171
Tu_triky wrote:16G SDHC memory card

As the resolution of digital cameras increases, memory cards with larger capacity are needed. Evergreen has released a 16G SDHC memory card with high-speed writing and reading access (class 6). You don't have to worry about memory capacity anymore and can take photos and videos with your high-spec camera as much as you want.

DNF-SDH16C6, Evergreen
9,999 yen
http://www.donya.jp/item/5233.html

January 23, 2008

Wow, 16GB for only about $100USD?

Or is that a typo?
28 Jan 2008, 01:04 #4172
bmwracer wrote:
Wow, 16GB for only about $100USD?

Or is that a typo?


That's what I said....no apparently it's the real deal. You can click the link and check for yourself.

Maybe the memory is made of cardboard.
28 Jan 2008, 01:29 #4173
Tu_triky wrote:That's what I said....no apparently it's the real deal. You can click the link and check for yourself.

Maybe the memory is made of cardboard.

It probably write the data on the disc from right to left. :beaten:
28 Jan 2008, 01:35 #4174
bmwracer wrote:
It probably write the data on the disc from right to left. :beaten:


:hehe: Yes because the atoms that make the card spin that way too
28 Jan 2008, 01:40 #4175
Tu_triky wrote: :hehe: Yes because the atoms that make the card spin that way too

LOL, could be... I don't remember my atomic theory from college. :beaten:
28 Jan 2008, 01:46 #4176
bmwracer wrote:
LOL, could be... I don't remember my atomic theory from college. :beaten:


I didn't take physics nor would I have passed. I'm a Letters kind of guy.

:beaten:
28 Jan 2008, 02:46 #4177
Tu_triky wrote:I'm a Letters kind of guy.

Hiragana and Katakana letters, ne? ;)
28 Jan 2008, 02:53 #4178
bmwracer wrote:
Hiragana and Katakana letters, ne? ;)


HAHA...that would mean I'm a semi-literate guy. :hehe:
28 Jan 2008, 04:16 #4179
Anyone here have experience with a Seagate Barracuda Ultra ATA/100 internal HD? Looks to be an inexpensive, fast(7200RPM) option if it's reliable. Will it work with the IDE/EIDE internals of a Dell Dimension 4100?
28 Jan 2008, 04:33 #4180
Kijinnmaru wrote:Anyone here have experience with a Seagate Barracuda Ultra ATA/100 internal HD? Looks to be an inexpensive, fast(7200RPM) option if it's reliable. Will it work with the IDE/EIDE internals of a Dell Dimension 4100?

I think most of the name brands are fine and Seagate is one of the best, I think.

It *shouldn't* have a problem with your Dell, but you never can tell with some Dell products *not a fan of Dell*....

Replying needs an account. Registration opens soon.